Home Walton Walton Primo G2 Walton Software Walton Primo G2 Software Update Guide IMET Mobile Repairing Institute 11:27:00 AM A+ A- Print Email WALTON Primo G2 Software update (AP+BP) Guide Driver installation1) Install AP part driver Power off handset, press “Power key + Voice Up key” until the screen shows green, plug in usb cable, PC will remind you of installing new hardware. Unzip “ Driver”, select adb driver file, install AP driver. Path: Right click on My computer>Manage>Device manager>Android(Yellow notification)>Update driver software>browse path> select adb folder >Continue anyway>finish When you install AP driver successfully, you will find “Fastboot interface” in device manager. As below 2) Install BP part driver (i) Power off handset, press “Power key + Voice Down key” until the screen shows QPST mode, plug in 5Pin USB cable, Unzip “Driver”, select HK11-VB717-27_1.0.56 driver file, install BP driver. Path: Right click on My computer>Manage>Device manager>Tiyanyu HS-USB Driver (Yellow notification)>Update driver software>browse path> HK11-VB717-27_1.0.56\Win32\x86\free >Continue anyway>finish. (ii) When your BP driver is installed successfully, you will find Qualcomm HS-USB ports in device manager. As below: Software Upgrading:1.Download BP Open Primo Download V1.2.3 tool, set your handset into BP mode (Power key+ Voice down key) and connect your phone with USB cable. 1. Click set path>Browse folder>Select 592522_8550_WCDMA_V000001 2. Click Download All2.AP Download: Open Primo Flasher V1.0 tool, set your handset into AP mode (Power key+ Voice up key) and connect your phone with USB cable. 1. Click Set path>Browse folder>Select 592522_8550_V001006 2. Click Ok for Start download. Note: If your antivirus detects Primo Flash Tool as virus, disable your antivirus till software is finish. Walton Primo G2 Software Update Guide Walton, Walton Primo G2, Walton Software Tweet Share Share Share Share Share