Nokia X1 Lcd Ways Display Jumper Problem
This solution covers for hardware level of repair for Nokia X1-00 Display Problem and Also you will find Nokia X1 Display Ways and Jumpers information in the diagrams in this article.
Just see the solution preview below for it shows which components needs to be check and replace if the there is No Display Working on phone or Display problem of the Nokia X1 goes wrong. This solution may help if you already done a software calibration method and tried replacing the Display but the problem continues.
Do these solutions step by step.
If the above solution fails then the next thing that you need to do is to check out any traces of water damage on your phone. If you find your phone water damaged then clean all its traces, after wards gently heat your board as well as components for a few seconds in order to wipe out all the traces of water damage on your phone. Afterwards check.
Now check the connection between diode and the first pin of display connector (on – board), if there is no continuity between 1st pin of the display connector and diode then solder board pins and check.
If the above step fails then it means that diode might be faulty or is disconnected from the board. In order to resolve that gently heat diode and check, if it is still find to be faulty then replace diode.
If the above step fails in resolving this issue then it means your Nokia X1-00 display screen is faulty and you need to change it.
Nokia X1-00 Display Light IC Solution Jumper Problem Ways LCD Display Light Not Working
Nokia X1 LCD Display Light, Display Light Problem, Display Light Solution, Display Light Jumpers, Samsung