Nokia 210 Power ON-OFF Key Track, Jumper Ways Solution
This solution provides the connection line paths of the Nokia Asha 210 Power ON-OFF/END switch button key. This may help fix if the phone doesn’t tuns ON but it shows charging indication when the battery charger is plug-in.
So if your Nokia Asha 210 power button is not working to repair it you just need to replace it with a new one. If the prints of the button are damaged then you are going to have to make the jumpers as shown in the diagram.
To fix this problem, you may need to clean first the power key’s contact pads for possible oxidation build up. If it seems cleaned but however still doesn’t respond, refer to this solution below for it shows the connection line paths of the power key, then do some test and tracing procedures.
Just refer to the solution below and locate the highlighted components where the said power on off key is being connected.
Repair hints for Power Switch problem on Nokia Asha 210:
1. Check the power switch assembly, if the assembly is damaged replace the switch.
Sometimes even if the power switch is not not visually damaged, see to it that it still working by using a
2. For lifted button switch solder terminal pads on the PCB board, manage to re-establish the switch to its original position and bond it perfectly so that it won’t easily break. Then manage to reconnect the power switch line paths and the ground connection. If you can see an empty components solder pads just below of it, you can connect it to that spot. that is also connected to the power switch.Nokia 210 Power Button Ways, Nokia Asha 210 On Off Key Jumper Solution, Set Is Dead Problem
Nokia Asha 210,Power Button,Power Key,Power Switch,On Off Button, On-Off Switch, Power Problem