Samsung SM-J120H Not Charging Problem Solution Usb Ways
Sony Xperia T2 Ultra,Charging,Solution,Jumper,Problem,Ways
Here is the solution for Samsung Galaxy J1 J120H Not Charging problem like there is No Charging indication shows on the display when the battery charger is being plug-in.
This problem is may caused by a faulty charger or a faulty components on Samsung SM-J120H PCB board. This problem may sometimes happens if the device suffered wet or water damaged or just exist.
Before proceeding, ensure that the battery and the battery charger are in good working condition.
– Check all the components shown on the image below, you may start by checking the USB pin connector.
– Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
– Trace each of the connection line paths from USB pins down to the components where it is directly connected.
Reasons of Problems
Phone could be water damaged.
Dust particles might be present in charging connector.
Your charger might be faulty.
Connection in the phone might be broken.
Phone is encountered any physical damage.
Any of the capacitors might be faulty.
Charging IC might be faulty. Clean dust on charging connector, you can do that simply with the help of a brush.
If same problem replace charging connector and check.
If same problem Check charging connector ways.
If you have further Questions please leave a comment.
Keep in mind:- The every solutions posted on Our website is well tested before by our specialist team, But still we do not take any responsibility for any damage it may cause to your cell phone. Use these repairing solutions at your own Risk, Thank you.
Samsung Galaxy J1 J120H Charging,Jumper,Problem,Ways, solution
Samsung SM-J120H,Charging,Charging Problem,Charging Solution,Charging Jumpers,Charging Ways
Sony Xperia T2 Ultra,Charging,Solution,Jumper,Problem,Ways
Here is the solution for Samsung Galaxy J1 J120H Not Charging problem like there is No Charging indication shows on the display when the battery charger is being plug-in.
This problem is may caused by a faulty charger or a faulty components on Samsung SM-J120H PCB board. This problem may sometimes happens if the device suffered wet or water damaged or just exist.
Before proceeding, ensure that the battery and the battery charger are in good working condition.
– Check all the components shown on the image below, you may start by checking the USB pin connector.
– Then the fuse, diode, capacitors and filter coil for possible open or short circuit.
– Trace each of the connection line paths from USB pins down to the components where it is directly connected.
Reasons of Problems
Phone could be water damaged.
Dust particles might be present in charging connector.
Your charger might be faulty.
Connection in the phone might be broken.
Phone is encountered any physical damage.
Any of the capacitors might be faulty.
Charging IC might be faulty. Clean dust on charging connector, you can do that simply with the help of a brush.
If same problem replace charging connector and check.
If same problem Check charging connector ways.
If you have further Questions please leave a comment.
Keep in mind:- The every solutions posted on Our website is well tested before by our specialist team, But still we do not take any responsibility for any damage it may cause to your cell phone. Use these repairing solutions at your own Risk, Thank you.
Samsung Galaxy J1 J120H Charging,Jumper,Problem,Ways, solution
Samsung SM-J120H,Charging,Charging Problem,Charging Solution,Charging Jumpers,Charging Ways
Post A Comment: