IMET

A33, Govind Plaza,
Lalkurti, Meerut Cantt. (UP)
PIN: 250001
Contact No +919411667220

Email:
bijendra.narsinghani@gmail.com

Website:
Navigation

Xiaomi Note 3 Unbrick, Firmware & Guides [Qualcomm]

Xiaomi Note 3 Unbrick, Firmware & Guides [Qualcomm]






Tools & Firmware's:

Flash Tool MiFlash_2016.03.30.exe

Stock Firmwares:

China Stable (V7.2.2.0) : Download Here

Global Stable (V7.1.8.0) : Download Here

Latest:

China Stable (V7.2.3.0) : Download Here

Global Stable (V7.2.3.0) : Download Here


Custom Recovery & Supersu.zip

Twrp Recovery

Other:

Edited fixed flash_all.bat and rawprogram0.xml


Procedure 1 :Flashing guide for Bricked Phone with Locked Boot-loader

Note:This guide vil show you how to Reboot Into EDL mode when you re on bootloop
on MI Logo or with 3 Dots.


Manual method to get EDL Mode:

* 1st you have to power off your phone,In some case if unable to power off then you have to wait until it discharge and power off
otherwise you have to open the mobile and remove battery to power off your phone.

* If you power off your phone by discharging then before start charge your battery again to least 25 to 40%.

* Disconnect yur phone form charger.

* Now Important Step, Connect usb cable and immediately press both Vol Keys or press both the vol keys nd connect the usb to Get EDL mode.
if any thing goes wrong it vil show mi logo or boot it to test mode.

if its successfully done your phone will be detected in device manager as

If you see QHUSB_BULK in device manager update the qualcomm driver from mi-flash tool Installed path.

Note:In windows 64 bit Disable Driver Signature Enforcement before update Driver
otherwise it vil not install.

If fully hard bricked, you have to disassemble your phone and use test point to get EDL mode.



* Disconnect all the cables and flat cables

* Reconnect only Battery Display and USB

* Connect the phone to PC, open Mi Flash and load the ROM.

* Then short the points now your device should detect as EDL mode "Qualcomm HSUSB QLoader 9008"

Flashing Method By Mi Flash Tool:

* Extract the firmware.

* Run mi flash tool and show the path where you extracted the firmware folder.

* Goto Advance tab and select files lik gvn in the below image.



* Now Press Refresh and You should see you phone com ported detected.

* At last Press Flash nd it should Flash your Phone.

Note :After its Done Manually Reboot.


If you face same error like below given



Share
Banner

Bijendra Narsinghani

Post A Comment: