Resurrecting HTC WildFireS is easy. Phone is auto powered on with USB Data Cable connected to the PC. Battery presence is not required; connection can be established with detached board.
In case you have no USB cable near, make sure battery is charged enough and hold Power On button during initiation of JTAG connection.
Resurrector will reflash radio’s boot zone and will re-write PDA’s SPL to 1.01.0002 version. Additionally to SPL and Radio zones, the zone which contains Model ID is re-flashed too. Thus after resurrection phone will have Model ID = ‘PC4910000′. Additionally, you can check ‘Repair RECOVERY zones’ to reflash android BOOT and RECOVERY code.
- Solder JTAG cable to HTC WildFireS JTAG pads;
- Insert USB Data cable into board and PC;
- Make sure HTC WildFireS is selected in the list of models;
- If you use battery, press Power On key;
- Click Resurrect button;
- Wait till software signals a successful operation completion;
- Disconnect power supply, de-solder JTAG wires;
- Disconnect PC cable;
- Insert battery;
- Hold ‘Volume Down’ key and press ‘Power ON’ button. In few seconds you should see usual android boot mode screen.
- Samsung B139 Repair/Unbrick, Read/Write NOR Flash
- Samsung B259 Repair/Unbrick, Read/Write NOR Flash
- Samsung B309 Repair/Unbrick, Read/Write NOR Flash
- Samsung B319 Repair/Unbrick, Read/Write NOR Flash
- Samsung B379 Repair/Unbrick, Read/Write NOR Flash
- Samsung B619 Repair/Unbrick, Read/Write NOR Flash
- Huawei C31 Repair, Read/Write NOR flash