IMET

A33, Govind Plaza,
Lalkurti, Meerut Cantt. (UP)
PIN: 250001
Contact No +919411667220

Email:
bijendra.narsinghani@gmail.com

Website:
Navigation

LG G Pro Lite D680 Touch Screen Not Working Solution

LG G Pro Lite D680 Touch Screen Not Working Solution
LG G Pro Lite D680 Touch Screen Not Working Solution Ways Jumper
If you are looking and having trouble finding where to put a jumper if the touchscreen pin connector is already gone or lifted due to water water damaged on LG G Pro Lite D680. This solution might help you to ease out your hard time finding where to solder a jumper wire on it just to fix a touchscreen not working problem.

Touch panel in LG D680 is not very strong so if too much pressure is put on the phone it can damage the touch screen to the point of it not working at all. If that happens there is no proper way to repair it, you have to buy a new touch panel from the market and replace it with the old one.
This solution exactly shows the connection line paths of the touchscreen pin connector of the LG G Pro Lite D680 PCB board layout. You may only need to check its corresponding pinouts if the connection were already cut-off or have an open circuit, then solder a jumper on it, for it is only the options.



If the above step fails then look for any traces of water damage on your LG G Pro Lite D680 motherboard. In case you find that then properly clean the entire board and also use a heat gun for a few seconds so that there are no traces of water left behind. This is also a one effective solution for that and any phone that has touch screen problem due to water or moisture is able to overcome this type of problem.
If you have further questions please don’t hesitate to leave a comment.

Note: Every repairing solution posted here is tested by at least one member of our team. Use the information available here at Your Own Risk. We are not responsible if any harm comes to your device during the repairing process.
LG G Pro Lite D680 Touch Screen Ways Solution Ic Jumper



Share
Banner

Bijendra Narsinghani

Post A Comment:

0 comments: